About Pad Corp PCWH-1 Weedicide Nozzle
Pad Corp PCWH-1 Herbicide Spray Nozzle Weedicide Nozzle Cap from Pad Corp is a precision single-nozzle weedicide nozzle cap designed for spot weed control in kitchen gardens, raised beds, polyhouse plots, and small field corners. Built from 100% pure virgin plastic, Pad Corp PCWH-1 Herbicide Spray Nozzle throws a controlled, narrow spray band right onto the target weed and shields surrounding crops from chemical drift. Pad Corp PCWH-1 Herbicide Spray Nozzle works at low knapsack pump pressure, uses less herbicide per pass, and gives an accurate aim every time.
Key Benefits
-
Precision spot spraying: Sprays a narrow stream directly on the weed, useful for killing weeds growing close to vegetable, fruit, and flower plants
-
Saves herbicide cost: Single-outlet design uses much less herbicide per round than a broadcast spray, cutting chemical cost on small plots
-
Pure virgin plastic body: Heavy-duty plastic holds up well against glyphosate, paraquat, atrazine, and other common weed killers
-
Works on hand pumps: Fits hand-pumped knapsack sprayers, so no battery sprayer or power machine is needed
-
Clear dome body: Transparent design lets the farmer see the weed below and place the spray right where it's needed
-
Quick hand-screw fit: Screws onto any outer or inner thread sprayer lance by hand, no extra tools needed
Product Specifications
Specification |
Details |
Product Name |
Pad Corp PCWH-1 Herbicide Spray Nozzle |
Brand |
Pad Corp |
Type |
Single Nozzle Herbicide Spray Hood |
Material |
100% Pure Virgin Plastic |
Body |
Transparent Dome |
Nozzle Count |
1 (Single Nozzle) |
Lance Fit |
Outer / Inner Thread (Any Indian Lance) |
Spray Band |
Narrow, Focused (15-25 cm per pass) |
Best Use |
Spot Spraying, Kitchen Gardens, Polyhouses, Raised Beds |
Resistance |
Water, Rust, Herbicide Chemicals |
Size |
27.5 cm × 14 cm × 9.5 cm |
Pad Corp PCWH-1 Weedicide Nozzle Usage
- Rinse the nozzle under tap water to clear factory dust before first use
- Unscrew the regular jet or flood nozzle from the sprayer lance tip
- Hand-thread the sprayer hood onto the lance and tighten until the dome sits firmly without any wobble
- Mix the herbicide solution in the tank as per label rate, using a clean tank that has never carried insecticide before
- Pump the knapsack to working pressure, lower the nozzle straight over the target weed, and squeeze the lance trigger
- Hold the spray hood about 12-15 cm above the soil for the best drift block and full weed wetting
- Walk row to row in a straight line, lifting the nozzle clear of crop stems while moving between target weeds
- Wash the sprayer hood with mild soapy water after each session to clear chemical traces and prevent nozzle blockage
Safety Precautions
- Wear nitrile gloves and a mask while handling the nozzle cap, as fresh herbicide residue clings to the plastic dome edge
- Keep the sprayer hood away from kitchen surfaces, cooking pots, and child play areas always during and after spraying
- Avoid breathing in the spray mist exiting the nozzle, even in light wind, stay upwind during the entire spray run
- Never store the nozzle cap inside the same shelf as food grains, animal feed, or seed packs
Pad Corp PCWH-1 Weedicide Nozzle Expert Advice
"For best results with Pad Corp PCWH-1 Herbicide Spray Nozzle, hold it about 12-15 cm above the soil and keep a steady, close aim on the weed to block drift onto nearby crops. Hand-tighten the fit only and wash the hood after every session to keep the nozzle working accurately." - BigHaat Agronomy Expert
Additional Information
- Hand-tighten the spray hood only, never force-thread it with pliers, as the virgin plastic can split at the joint
- Replace the sprayer hood if the dome turns cloudy, develops cracks, or starts dripping at the threads
- Actual performance may vary based on field conditions, spray technique, and usage practices.
Disclaimer: The information provided is for reference purposes only. Please refer to the product manual for detailed operating and safety instructions.
